L40 Web Spray Contact Adhesive 500ml

• This product is designed to be applied to two surfaces to
be bonded together. Make sure that surfaces are clean, dry
and free from dirt, dust, oil, loose paint, wax or grease, etc.
For best results, the temperature of the adhesive and the
surfaces being bonded should be between 60 degrees F – 80
degrees F (16 degrees C – 27 degrees C).

• Use with adequate ventilation. When possible we
recommend shaking the canister well before using.

• Prior to use, Check compatibility by spraying a small test
patch of the adhesive on the substrate. This product may
degrade some substrates. Spray about 10-20 cm (4” – 8”)
away at a 90 degree angle to the surface, applying a uniform,
even coat of adhesive to obtain 80% to 100% coverage of the
surface. If necessary, spray another coat of adhesive in areas
that appear to need more adhesive. Spray both surfaces
to be bonded, one surface vertically and the other surface
horizontally. Allow the adhesive to tack off until no adhesive
transfers to the knuckle when touched.

• Adhere surfaces and press together with adequate pressure.
A roller is recommended to apply a uniform pressure to
achieve maximum strength. Allow 24 hours for the adhesive
to fully cure.